Get the latest weekly fluid news direct to your inbox.

Sign up for our free newsletter now.

Titan unveils low volume, high performance flowmeter for process and control applications

Titan Enterprises, a UK flow equipment specialist, has introduced Process Atrato, a new low volume, high performance ultrasonic flowmeter packaged to address the challenges of the process and control environment.

The compact flowmeter combines the advantages of Titan’s Atrato ultrasonic technology – including high linearity and sensitivity and wide flow range linearity – with a new durable construction.

Built from 316 stainless steel and PEEK, the Process Atrato is supplied sealed to the IP65 standard.

The meter’s housing and high performance makes it possible for engineers to reduce the cost of ownership compared to existing flow measurement technologies serving the process and control market, Titan says.

Rated for use up to 65°C and 20 bar, the Process Atrato is available in four models operating over flow ranges from 2ml/min to 15l/min at an accuracy of ±1% over the whole flow range.

Each meter is calibrated with a pre-set “K” factor, making all meters of the same flow range fully interchangeable, which simplifies assembly and setup procedures.

The meter comes with two frequency outputs (PNP and NPN) as standard and two multicolour LEDs indicate signal strength, power malfunctions, and pulse outputs.

Electrical connections are through a standard M12 four pin, sensor connector.

The advanced Atrato signal processing system permits flow measurement across the whole Reynolds number range, allowing both viscous and non-viscous products to be metered anywhere.